[ad_1]
There have been several models of the Samsung Laser Printer released into the market. However, many seem to present varying degrees of problems. Here are some common error codes in addition to troubleshooting tips:
error message: Scanning error
This error message is essentially a hardware failure. You can try to replace the USB cable. Sometimes poor quality cables can not transmit the data in great need of a scanner.
error message: Paper Jam
This is what happens when the paper is jammed in the Samsung laser printer. You need to check the output rollers located next to the sensor. Maybe it’s the wrong position or is damaged. If nothing works, try replacing it with a new sensor.
Error message: square prints
Sometimes there may be a Samsung laser printer prints out the squares instead of regular text. This can happen if you are using Firefox or printing content from sites which do not recognize the font used in the text. To solve this problem, you must install all the drivers involved again. If this does not help then visit the printers and faxes folder, select your printer and select Properties.
error message: missing print
Sometimes, a portion of the site can be free printing. This can happen because of incorrect paper size configuration. Check the settings and try again.
Error code: H2
This code indicates a problem with the fuser warming. Make sure that the cables are connected and that no point is missing.
error message: Media tray is empty
Sometimes even if the tray is full of paper may get this error message, Samsung laser printer. Try updating the drivers by visiting the Samsung site. This corrects issues.
Error: Toner light still on
after
replacement of the cartridge can still find the toner light switched on constantly. It is necessary to check the fuse located on the front of the cartridge. You could try 50 seconds replaced by this one. This error usually occurs in the Samsung SCX-4216F.
Code 24
This error code indicates that there is too much overload, if the print job is concerned. You can select the button called ‘continue’ and then try reducing the print job.
Code 50
This indicates a malfunction in the fuser. This means the fuser is not heating up. Try turning off your Samsung Laser Printer or resetting the printer for about 15 minutes and then turn it on again. In this case, it does not solve the problem, may indicate a problem with the fuser or the network.
Code 16
This code means that the toner is low. This means that the distribution inside the cartridge is inadequate. You need to remove the cartridge and put it back and front gently. If this does not work, try to replace the cartridge. You could also try cleaning up the contacts.
[ad_2]
Source by James Kara Murat